Network Administrator
Interview Questions
1.Which of the following commands can be used to delete the configuration stored in NVRAM?
A) erase startup-config
B) erase running-config
C) delete nvram
D) erase nvram
Answer:
A and C
2.What port does telnet use by default?
Answer:
23
3.Is this statement correct or incorrect? “Layer 2 of the OSI model is responsible for switching data whereas Layer 3 of the OSI model is responsible for routing the data.”
A) Correct
B) Incorrect
Answer:
A
4.If an Ethernet port on router was assigned an IP address of 172.16.1.1/20, what is the maximum number of hosts allowed on this subnet?
A) 2046
B) 8190
C) 4094
D) 4096
E) 1024
Answer:
C
5. At which OSI layer does data translation and code formatting occur?
A: Network
B: Physical
C: Data link
D: Transport
E: Session
F: Presentation
Answer:
F
6.What is a trunk link?
A) A link that is only part of one VLAN and is referred to as the native VLAN of the port
B) A link that can carry multiple VLANs
C) A switch port connected to the Internet
D) Data and voice capability on the same interface
Answer:
B
7.What PPP protocol provides dynamic addressing, authentication, and multilink?
A) HDLC
B) LCP
C) NCP
D) X.25
Answer:
B
8.Which of the following statements is/are true about ‘metrics’ used in routing protocols?
A) A metric is a measure of trustworthiness and availability of a route.
B) A metric is the administrative distance of a routing protocol.
C) Both of the Above
D) None of the Above
Answer:
A
9.Which of the following routes will be used to forward data in a situation where a routing table contains static, RIP, and IGRP routes destined to the same network with each set to its default administrative distance?
A) The IGRP route
B) The static route
C) The RIP route
D) All three will load balance.
Answer:
B
10.MAC addresses are a feature of the _______________ layer.
A) Logical Link Control Layer
B) Data Link Layer
C) Physical Layer
D) None of the Above
Answer:
B
You must log in to post a comment.